So I revised the original design to have provisions for dust cover.
I have added small gaps(9mm) between the mounting plates of the x and z axis:
A good improvement compared to the original design:
Friday, February 24, 2017
X and Z Axis Upgrade
The current design has no provisions for dust covers on the x and z axis, Dust covers are needed because dust easily sticks on the linear rails and this will certainly destroy the machine easily.
So I revised the original design to have provisions for dust cover.
I have added small gaps(9mm) between the mounting plates of the x and z axis:
So I revised the original design to have provisions for dust cover.
I have added small gaps(9mm) between the mounting plates of the x and z axis:
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment